using non SI transducer

General Discussion
Post Reply
finny
Posts: 1
Joined: Tue Aug 02, 2016 9:27 pm

using non SI transducer

Post by finny » Tue Aug 02, 2016 9:38 pm

Hi,

I have a 797c SI unit
I also have a plain old 525 unit, the site says the transducer is the XNT 9 20 T

I don't have a lot of battery juice so I wan to cut down power usage. I think one way to do this is to use the 525's transducer.
Can I do this?
If I have both units hooked up with a y cable can I use the interface to turn off one of the transducers?

thanks.
finny

Wayne P.
Posts: 1613
Joined: Sat Jun 05, 2010 5:24 pm

Re: using non SI transducer

Post by Wayne P. » Wed Aug 03, 2016 10:17 am

Check the Sonar menu for the Connected Transducer setting.

Change that to US2 or Dual Beam and it will turn off Imaging and just use the 2D crystal in the SI transducer or you can connect the XNT 9 20 T in its place and have a 2D-only unit.

There is no Y cable will not do what you want.
Wayne Purdum
Charlottesville, Va.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests

Created by Matti from StylesFactory.pl and Warlords of Draenor
Powered by phpBB® Forum Software © phpBB Limited
 

 

cron