Using AutoChart with 798ci HD SI with Updated Firmware 7.120

Official Firmware, Side Image Viewers, Map Overlays, 3rd Party Apps, etc..
Post Reply
Sam Menard
Posts: 3
Joined: Tue Aug 19, 2014 8:06 pm

Using AutoChart with 798ci HD SI with Updated Firmware 7.120

Post by Sam Menard » Sat Aug 23, 2014 8:51 am

Following the instructions, I installed the update in my unit and restored my Autochart SD card to it's original format but was pulling my hair out because my maps (which I previously created using the work-around) wouldn't show up on my unit. Then I found out that, under the Chart tab in your unit's main menu, there is a selection for Base Layer and the choice is either default or AC. When I select AC, I get my maps. However I can't apply this setting permanently. Every time I start up, i have to reset it back to AC. What's up with that?? Anyone else experiencing this?

Sam

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests

Created by Matti from StylesFactory.pl and Warlords of Draenor
Powered by phpBB® Forum Software © phpBB Limited
 

 

cron