Custom mount and onix recognizes 360!!!

Anything Related to Humminbird 360 Degree Imaging Systems
Post Reply
SgtPalm1
Posts: 2
Joined: Sun Jul 12, 2015 7:40 pm

Custom mount and onix recognizes 360!!!

Post by SgtPalm1 » Fri Jul 17, 2015 11:23 pm

I have been on just about every forum to find a way to mount the 360 where I could remove it easily if needed. There is a wealth of knowledge out here so I thought I would add my solution to the bow mount 360. I took an old evinrude trolling motor mount, rebuilt it. It was the smallest flip down locking mount I could find and it had a sleeve that was 1.5" so a sheet of cork cut to size worked well to take up the gap.
Thanks for all the posts. I also found the fix for the 360 not being recognized by the onix. Older 360 will not update on new onix with 2.30.
If you backdate your software on the onix to the 2.0 with the 360 powered on ....you will find that that the onix only updates the 360 software and does not backdate your onix. I spent several days, rebooting, rewiring.......after much frustration I tried backdating the onix. It worked perfectly. The onix now recognizes the 360, the 360 software is up to date and the onix software is 2.30. Everything is working great for now.
Image
Image

Gashisoki
Posts: 2
Joined: Fri Aug 14, 2015 4:09 am

Re: Custom mount and onix recognizes 360!!!

Post by Gashisoki » Fri Aug 14, 2015 4:10 am

I doubt I need more information in order to take advantage of.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest

Created by Matti from StylesFactory.pl and Warlords of Draenor
Powered by phpBB® Forum Software © phpBB Limited
 

 

cron