360 on 1199 rebooting

Anything Related to Humminbird 360 Degree Imaging Systems
Post Reply
dla326
Posts: 1
Joined: Sun Apr 10, 2016 6:28 pm

360 on 1199 rebooting

Post by dla326 » Sun Apr 10, 2016 6:39 pm

I have an 1199 SI. Added a 360. The 1199 picked up the 360 and worked for about 5 minutes, then rebooted. After the initial reboot the 1199 now reboots again shortly after starting, (I think when it senses the 360). I disconnect the 360 and the 1199 works fine. Also, I do not think the 1199 was picking up the external GPS either. Software on the 1199 is 7.650, software on the 360 is 2.030. I downloaded the 2.030, but it did not seem to me that the 1199 did anything with it when I fed it the SD. Can anybody help me while I am still sane? Thanks

Spd 135
Posts: 14
Joined: Wed Apr 09, 2014 8:25 am

Re: 360 on 1199 rebooting

Post by Spd 135 » Tue Apr 12, 2016 11:45 pm

Are you using a separate power source on each unit, or the same one? I use a single source but I make sure the voltage is 12v. Sometimes I use two sources. The 360 uses a lot of juice. If it is rebooting it sounds like a power issue. Try a new and fully charged battery, or two, and see if that helps. Also make sure your ground is solid. Hope it helps.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest

Created by Matti from StylesFactory.pl and Warlords of Draenor
Powered by phpBB® Forum Software © phpBB Limited
 

 

cron